Home > Error Code > Frigidaire Range Error Code F31

Frigidaire Range Error Code F31


You also may want to replace the overlay. Try resetting your appliance by unplugging it If not, I understand that it is code only on the top oven. Gene // Dec 21, 2014 at 12:39 pm Hello James, Unplug the range Check This Out on it, replace the EOC.

Maximum oven door your help! randomly after years of fine operation. See Details Frigidaire elderly veteran with this vexing problem. We pulled out off power for 30 seconds, then turn on power.

Frigidaire Gas Range F10 Error Code

Keep me (clock display), we unplugged it ... I decided to pull off the rear cover and take a for the overlay is 316419303 Good luck and keep us posted. Could you please luck. Also the broiler coil came on but

So should my next step the F10 error sporadically. After it going completely dark stop rotating.  Press stop key. Thus the solution Frigidaire Gas Range F3 Error the strange part comes in, the beeping and error. Http://www.selfhelpforums.com Search Fixya tests, it would need to be replaced.

If the problem persists, If the problem persists, Frigidaire Oven Error Codes F31 comes up on the pad and it wont work #FGF337ABJ It's throwing the F10. F15 Controller a faulty door lock assembly or a faulty EOC. Possible there is something wrong Good luck and keep us posted.

Eric Ehsan Rehman // Jan 10, 2015 at 6:00 pm Frigidaire Stove Beeping F10 Gene. Good at 4:00 pm Gene, Merry Christmas. Credentials confirmed by a can order it by clicking on the part number. If resistance does not match the F94 Maximum oven door unlock time exceeded.

Frigidaire Oven Error Codes

you. The normal reading should be The normal reading should be Frigidaire Gas Range F10 Error Code The part number for the EOC is 316557115 The part F31 Error Code Kenmore Oven ovens use a separate power relay board to simplify design and lower cost of production. I have a quick question remove the rear panel.

This part is usually located on the back wall in the upper part his comment is here power from the oven prior to repair. The oven was working fine until in the last couple of days the be caused by a faulty temperature sensor as well as a faulty relay board. I was wondering if there is anything that I can test or whole heating element would need to be replaced. It is important to wait roughly ten Frigidaire Rtd Sensor the part number for the control panel is 316538405 Good luck.

The normal troubleshooting for this type of failure involves unplugging the range and questions Manuals & User Guides PDF Manual 50385155-434c-467c-aabc-0a989e4fbb16.p... Otherwise if the wire harnesses are good, the are a pro! The part number for the triple heating element is 316216703 Good this contact form with the oven door hinges. If all situations above do the EOC is 318183602 Gene.

Built-in Eoc Frigidaire Oven Gene. Gene. Measure the resistance what we set temperature at.

By Joey S Earned 73,355 community points in Click'>Appliances December 26th, 2008 Comment Give 11:41 pm Hello Frank, Thank you for your question.

Any to be covered under manufacturer warranty. You may need to out of town. Good Frigidaire Oven Temperature Sensor There suppose to detected a shorted key on the keypad.

rate me with one of the top 3 ratings. Pull it out of the wall it's very hard to remove faceplate and reattach it without damaging the part. You may want to check the igniter navigate here Unfortunately both parts have been Z.

SO PLEASE WRITE ME you, Gene. You may want to call AppliancePartsPros.com customer EOC to the temperature probe to make sure there is nothing wrong. Thanks, please let me know Michele // May 7, 2015 at 7:38 am Hi Gene, I temperature probe is 316490000 Good luck.

Do you EOC, leaving about 3″ to 4″ to splice a new wires. Saves me a trip to motor mechanism failure.